this post was submitted on 12 Nov 2023
496 points (94.6% liked)
Memes
8321 readers
1561 users here now
Post memes here.
A meme is an idea, behavior, or style that spreads by means of imitation from person to person within a culture and often carries symbolic meaning representing a particular phenomenon or theme.
An Internet meme or meme, is a cultural item that is spread via the Internet, often through social media platforms. The name is by the concept of memes proposed by Richard Dawkins in 1972. Internet memes can take various forms, such as images, videos, GIFs, and various other viral sensations.
- Wait at least 2 months before reposting
- No explicitly political content (about political figures, political events, elections and so on), [email protected] can be better place for that
- Use NSFW marking accordingly
Laittakaa meemejä tänne.
- Odota ainakin 2 kuukautta ennen meemin postaamista uudelleen
- Ei selkeän poliittista sisältöä (poliitikoista, poliittisista tapahtumista, vaaleista jne) parempi paikka esim. [email protected]
- Merkitse K18-sisältö tarpeen mukaan
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Robertson Square that high up? This list must have a few loose screws.
I've used them very rarely, but I've never had one strip unlike everything beneath it so I can't complain.
I can complain the screw bit gets stuck inside each time and due to it being barley used in the US they are a pain to find.
In Canada it's my preferred screw. Sometimes it gets stuck but rarely, and if it does you just back off / reverse a little bit. Its amazing because you don't need magnets to get it to stay on the end of your driver as you line it up so much easier to do everything one handed, rarely ever strips, and you can torque it a stupid amount if you want to
Example of a Canadian problem: Using impact driver drill to remove Robertson screws, the screws get stuck so good that you can shake the tool by the screw an it won't let go.
With the exception of pocket screws, weirdly. Pocket screws are somehow all Robertson.
They're used in cheap drywall screws and really suck in that application. The screw is too soft and the drivers are also usually too soft and strip. Once the driver starts to round over it's ruined.
All Canadian carpentry is done with Robertson or nails, drywall with Phillips because you don't want to apply a lot of torque so Phillips is perfect for that application because Phillips is shit.
That's a shitty screw then not the style of head issue?
Those aren't separable issues. A good drive system would do more to compensate for material deficiencies. A shitty torx screw is a lot better than a shitty robertson screw. Robertson is at best C tier.
I think torx are usually in higher end applications. So a shitty torx is going to be better quality materials than a equivalent shitty hex and Robertson.
I think you've been collecting shit square systems then. Try an actual set of Robertson screws with a Robertson driver, and you'll have a very different experience. Squares have no taper, Robertson's do. This is also assuming where ever you find them, they have named them correctly, but I swear they ain't the same.
Because they aren't the same, or compatible with eachother really. I use them a lot and can almost promise you the problem is when you involve the "square" one's at all. Robertsons all have a taper, so you can kinda use square bits/screws either each other, but they will chew the shit out of each other. Squares will always slip/strip, Robertson is far better IME.