Ergonomic, split and other weird keyboards
Posts must be of/about keyboards that have a clear delineation between the left and right halves of the keyboard, column stagger, or both. This includes one-handed (one half doesn't exist, what clearer delineation is that!?)
i.e. no regular non-split¹ row-stagger and no non-split¹ ortholinear²
¹ split meaning a separation of the halves, whether fixed in place or entirely separate, both are fine.
² ortholinear meaning keys layed out in a grid
No excessive posting/"shilling" for commercial purposes. Vendors are permitted to promote their products/services but keep it to a minimum and use the [vendor] flair. Posts that appear to be marketing without being transparent about it will be removed.
This subreddit is not a marketplace, please post on r/mechmarket or other relevant marketplace.
Great progress on #revxlp 10u now that batteries arrives. This time, even with pogo pins...
Hardware assembly almost done. Just got some software issues now - like always I try to get #miryoku on and did build the uf2 file already (the same way I did for the 12u version... hmm), copied over. Now a few keys seem to work but emitting very unexpected (not my miryoku colemak mod dh) keys... Do we need a special miryoku build?
@[email protected]
I checked connections from XIAO to the board and also took off the bottom plate, alu, just to be sure there is no shortcut. When plugging into usb-c and turning on, the green led charge indicator is on, seems to charge. I was previously able to connect via ble, too.
All right, here is my build run, it is a success and should build a basic miryoku for revxlp - details here https://github.com/hansamann/miryoku_zmk/actions/runs/6761313214
When I double press reset to have the USB storage of the XIAO appear, it will bring up an error "can't complete operation because some data in ...uf2 can't be read or written. But I think it copies the 359KB of uf2 over correctly. Then Finder of course shows an error as the device resets into the keyboard mode... all expected, right?
Unfortunately it still behaves weirdly. The outer three columns don't do anything. the 4th column top is a 'w' then below r and then x... leaves me clueless. I used JLCPCB with the assembly service. On the back of the pcba, I can see some D's are not places, for example DU D_U2 / D_U4 / D_U3 / D_U9 / D_U8 - but I assume that is all OK. I added the not swap sockets ONLY on the back as the assembly should do the rest on that side of the PCB.
If you could point me to a ready made build for the XIAO-nRF52840 with a default keymap I am happy to try that out.