bike wrench

837 readers

1 users here now

A place to ask bicycle repair questions, and for bike shop monkeys to share advanced non commercial wrenching resources (no YouTube self promotion). This is only for repair related topics.

[email protected]

founded 2 years ago

MODERATORS

j4k3

Looking for a smaller M6 inside threaded bolt (?) for my Bacchetta Giro Idler because I have an IGH. (lemmy.one)

submitted 2 years ago* (last edited 2 years ago) by [email protected] to c/bikewrench

3 comments fedilink hide all child comments

I have a Bacchetta Idler Bolt here. Better image from Bachetta. My issue is the Idler bolt is too long and is causing my Idler to go back and forth, which was fine when I had a cassette, but now I have an IGH, and I don't need it to slide. The sliding is causing my chain to pop off at the chainring. If I had a smaller Idler bolt, it would not slide.

you are viewing a single comment's thread
view the rest of the comments

[–] hollywoodhoogle 3 points 2 years ago (1 children)

You an cut both down to size.

Double check the female piece for thread length

For the male piece put a nut on the threads before you cut. Then file / grind the threads to a soft edge. Lastly unthread the nut. Make sure if spins freely before removing it all the way. If you need to thread it back in and re-file a bit do that before unthreading completely removing.

[–] [email protected] 2 points 2 years ago

I might buy an extra one and do that. I like it. Thanks