this post was submitted on 03 Oct 2023
35 points (97.3% liked)

homeassistant

12084 readers
6 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 1 year ago
MODERATORS
[email protected]
35
One success, one failure (lemmy.ml)
submitted 1 year ago by [email protected] to c/homeassistant
6 comments fedilink hide all child comments
 

I discovered some items on clearance at Home Depot, a Wyze Outdoor duplex plug and a Defiant smart plug. Did a little research on the modules I found inside and was pleased that both used esp32 microcontrollers. I got both disassembled, soldered up, and got to work flashing ESPHome, The Wyze was went well and is now integrated into my HA. Unfortunately the Defiant smart plug was defiant and when hooked up to do the flash I got a “Download mode disabled, reset with GPIO0 high.” Researching that I found that newer esp32 chips have a “Secure boot” fuse that once set disables future firmware updates from the UART. Not sure yet if there is an OTA exploit like the with BK7321 toya chips, but i’m not hopefull. If anyone knows of something let me know.

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 6 points 1 year ago* (last edited 1 year ago)

I think this one is a custom module, it solders into a slot on the main board vertically with pads on both sides of the modules bottom edge.

https://fccid.io/2AB2Q-LA02301/Users-Manual/11-User-Manual-4810925

Edit: fixed link