I’m working on a project with a 19x26" panel that I realized after gluing still has a bit of a twist in it across the three boards. In the past I’ve simply sanded down panels, but I think this one is going to require a plane. Thing is, I’m still fairly new to woodworking and don’t have any planes yet so I’ve been doing my homework on which to get.
I generally avoid buying junk tools, especially Chinese junk so that rules out a bunch of the options. Plus, I assume I’d find it difficult to tune up an old one since I’m not knowledgeable enough about them yet. Because of that I’ve ended up going straight to the top and considering either Lee Valley or Lie-Nielsen.
Given that my immediate task is to flatten a panel I was thinking either a #5 or #5-1/2 high angle jack plane knowing that I’d likely expand the collection in the future with a smoother as well, but for now I’m only looking for a first one.
Does that make sense for me? If so, any tips on deciding between the #5 and #5-1/2? The #5 is a bit cheaper, but it seems like the slightly bigger #5-1/2 would be good if I followed it up with a #4 in the future. Specifically I’ve been looking at:
Stumpy Nubs likes the Woodcraft hand planes, and they're about 30% less than the lie-nielsen/leevalley ones, still a lot of money, but they're also a lot less work to set up than a used one.
https://www.woodcraft.com/categories/planes
I personally got a couple old Stanleys and cleaned them up, but it took quite a bit of effort. Wasn't particularly difficult in terms of skill, but it wasn't just a 20 minute job either. Depending on what you get there's a lot of cleaning, adjusting, sharpening, etc. And getting it on eBay means you're never going to be 100% sure what you're in for.
It's fine doing it that way, but you need to be aware of what you're getting into. Sometimes if you have the $ to spend on a hobby, it's worth the cost to get a tool and finish the project.
I looked at WoodRiver, but if I was going to buy a new plane I'd rather buy something American or Canadian made rather than from China. I'm always happy to pay a marginal premium if it means supporting domestic manufacturing.
But yeah, that's my fear if buying something used. I don't know what I'm looking for in terms of how much work it would take nor do I have the experience to tune it up properly.
4 or 5 of my planes are from eBay, the other 3 are from Facebook. Definitely not a 20 minute job, but under 2-2.5 hours each, and I rather enjoy the process of restoring tools. I get that it's easier, and no shame in spending some more money on nice tools you don't have to sink time into
Personally, I'd buy a used planer and a jointer before dropping close to $500 for a hand plane.