this post was submitted on 07 Aug 2023
124 points (97.7% liked)

Tabletop Miniatures

2213 readers
2 users here now

From D&D to Warhammer and beyond, and including printing, painting and everything else - this is a place to discuss and share everything about tabletop miniatures and terrain.

Stand out threads:

Friends of TabletopMinis:

founded 1 year ago
MODERATORS
ReadyUser31
[email protected]
124
My first attempt at freehand. Is it good? No. But am I proud of it? No. But, will I keep trying and improve slowly over time, and eventually master this difficult technique? Also no. (lemmy.world)
submitted 1 year ago by ReadyUser31 to c/tabletopminis
19 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[โ€“] ReadyUser31 2 points 1 year ago (1 children)

Ah no this is resin! It prints at 0.05mm.

I used to print in FDM but switched to resin earlier this year. There's more chemicals faff with the resin and needing ventilation etc but you can print a plate full of these models in about four hours, wash and cure, and be done with it. I was printing a single model at a time on FDM and it took like six hours.

[โ€“] Alteon 2 points 1 year ago

Wow.....that quality difference is fucking massive. 0.05mm is three times better than I'm able to do right now.