homeassistant

12225 readers

432 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago

MODERATORS

[email protected]

Light switch advice (self.homeassistant)

submitted 3 months ago by skullvalanche to c/homeassistant

18 comments fedilink hide all child comments

Just looking for some advice if the idea I have in mind is even feasible.

I have 2 light switches in my kitchen, one for some pendant lights, one for some overhead cannister lights.

I hate the placement of the switches, since the pendant lights which I prefer are far away from the actual doorways into the kitchen. Meanwhile the cannister lights are on the switches near the doors.

I'm looking to do some clever "hackery" to make it so the switches by the doors control the pendant lights, if possible, but I don't want to have to rewire things in the walls/ceilings.

Is there a good solution to this? I was looking at some Shelly switches, but I'm not sure those solve for the problem I wanna solve. I'm willing to swap out switches or wire in things near the lights, but trying to keep things simple as possible.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 3 points 3 months ago

A low-wiring way to do it would be to replace the bulbs with hue/similar bulbs, then just put a battery powered button in the location you want to have the controls. £10-ish for each button, plus however much the bulbs are.

Then just have the button set to toggle the lights on/off (you can also call different presets like dim etc by pressing and holding).
Then hass just directly sends the on/off commands to the bulbs.