this post was submitted on 23 Jul 2024
204 points (95.1% liked)
Asklemmy
43287 readers
1735 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy ๐
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- [email protected]: a community for finding communities
~Icon~ ~by~ ~@Double_[email protected]~
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Ironically just repaired my samsung dryer. Two drum felt gaskets, and the belt since it was disassembled. Front gasket failed and tore out. After examining all components, the torque of belt drive pulls on one side of drum, this puts extra pressure one one set of the drum rollers (Rh side). The rear one is near the hot air duct so it gets more extreme working conditions. bearing has worn shaft slightly and plastic wheel was partially fatigued, so looks like that rollet was dragging and so belt pulls down more front of drum pinching seal from extended weight and torque. The paint was worn off the housings in this section so felt gasket had more friction in that zone. The rear roller near the heating generator duct is a bad design. especially since it hangs off the back housing which is quite flexible in that area. Thankfully the repair was simple, other than completr disassembly , but not convinced it will last long.