Redneck Engineering

Decided to share an older "project" of mine - ms sculpt wireless to wired conversion (also, it runs qmk, so we get all its features). A sensible person would order a custom pcb (such projects exist on the web, take a look if you're interested), but I went with removing all the components except from the ribbon cable connector, sending the PCB smooth, gluing a piece of discount card to isolate the traces, gluing a Chinese rp2040 on top, and wiring all the necessary traces to it. No, it wasn't fun. Yes, it works.

Bonus: when I disassembled it now I found out the type-c wasn't soldered well and decided to separate from the board:

So, here we go: using phone as a poor man's microscope (note: also, still works)

The end result kinda doesn't give it out, so whatever (insert your frontend -- backend jokes here)

x-post from tg: https://t.me/theaftertimes/15396

So, a while ago I bought a cheapest oneplus 6 available in my area to subject it to a few experiments with running Linux. Among the other issues that came for that price, the power button was almost flush to the frame, hard to press, and had almost no feedback.

Today I finally got tired of it and decided to check what's wrong. The button itself turned out to be just fine, but the thingy that presses it looked weird:

After a few tries of gluing smth to extend the middle pin, I found out that I can just cut off a piece of plastic from the blister of my favorite headache pills and place it between the button and said thingy. Works wonders 🤣

Btw, the actual problem is that it was missing a few rubber spacers, as far as I understand, but whatever

I bust out a drill with a 7 mm nut setter.

Works like a charm. I give the trigger the lightest squeeze and I can grind my coffee in ½ the time with ⅒ the effort.