I find myself using a chunk of beeswax way more than I expected. It's handy for little spots where you need some quick lubrication, in addition to its usefulness as a finish.
this post was submitted on 23 Jun 2023
8 points (100.0% liked)
Woodworking
247 readers
1 users here now
A woodworking community for those migrating from Reddit.
founded 1 year ago
That is something I'd not heard of, thank you!
- there's no such thing as too many clamps
- a good rasp will pay for itself in sandpaper
- make or buy a marking gauge, and keep a sharp marking knife handy
- do you have enough clamps yet? no you don't
I definitely need more clamps! I think just work holding in general (and a decent bench to hold the work to) is something that I need to invest in.
A rasp is definitely on my list. Are there any particular types you recommend? I've got a shinto rasp on my wishlist, but I suspect that's not quite what you're talking about.
A sturdy bench is a good call. Hard to do much without a good bench.
For rasps the Shinto comes highly recommended. Otherwise hand stitched rasps are supposedly the best but also cost the most.
Diamond stones for me. I tried the sandpaper on glass method for quite a while and had no idea what I was missing until I got a set of quality diamond stones. Along with it I strop using a strip of denim with green compound.
A denim strop is a new one on me. How does it compare to leather?
To be honest I’ve never used a leather strop. I discovered this site when I was learning to sharpen knives. The guy behind the site had access to an electron microscope and used it to test different methods. He found that a loose strip of denim (fixed on one end and held in the hand with the other) with stropping compound worked better than a leather strop. I think for straight razors he added a step after with either dry denim or diamond spray. I figured if it was good enough for this guy it’s good enough for me.
I can say the denim works better than stropping compound on a flat wood board.
I use denim to keep disposable razors sharper longer based on some random thing I read.. never even thought to bring some out to the shop for stropping. Good tip.
A decent bench with a decent vice. Work holding is key.
I like having a Japanese pull saw handy for small, quick cuts.
If you are focusing on hand tools then I would say the following items are not always thought about, but indispensable once you use them.
- Shooting board
- Plane stop for your bench
- Cheap white candles (for your plane soles)
- Binding tape (better than masking tape for taping joints)
- Accu-Burr burnishing rod
Good list. The top two are on my list to make.
This is a reassuring list as I've already got the first three. First thing I made was a shooting board, and for a plane stop, well, I just screwed a thin strip of wood into my worktop. It's not great, but it does the job for now. Thanks for the input!
@Sausage good marking and layout tools. Not hand tool specific, but knowing that square is square (etc) is a prerequisite for a lot of precision work.
I use dial calipers all the time even though it's woodworking, not metalworking. Specifically fractional dial calipers. I have digital calipers but they can be a pain to interpret since they show to the nearest 1/64" and I usually need 32nds or 16ths. With an analog dial you can just glance at it and get the measurement you want.
They're great for measuring bolts and screws for pilot holes and measuring for joinery.