Faceting

362 readers

1 users here now

Community for discussing faceting and gemstones.

If you are a cutter, show off your work, provide tips and tricks or ask for advice.

If you don’t cut stones, feel free to ask questions!

No selling of stones, rough or anything else. You can however post links to vendors that you recommend.

founded 1 year ago

MODERATORS

Crylos

Faceting Process Step 3: Finish cutting girdle and pavilion (lemmy.world)

submitted 1 year ago* (last edited 1 year ago) by Crylos to c/faceting

2 comments fedilink hide all child comments

Now it's time to finish cutting the remaining tiers in the pavilion. Here is the diagram I'm cutting:

First thing I'm going to do is switch my lap to 1200 grit and recut the existing girdle and first tier facets. I'm doing this because the 1200 is more accurate and I want to get the cuts close to their final depths.

This is the result, can you see the issue?

There is a fracture in the stone right around where the girdle and facet meet, the shiny spot. The issue with this is two fold:

The stone will have a visible imperfection when finished
This is a weakness that may chip off the stone in the future.

So, I need to cut that out. What I need to do is reset to 90 degrees and cut that facet's depth down until the imperfection is removed.

While I was doing this I heard a crack sound, pulled up the stone and saw that the fracture had broken, and now I have a divot in the stone where it used to be.

So, keep cutting until it's gone

You can see in the above picture that the divot is gone, and the girdle facet is larger than its neighbors. Time to finish cutting the remaining girdle facets to match, and recut the second tier.

Before:

After:

Now I set my angle to 47 degrees and cut the next tier:

The first of the defined triangular facets appear. Something to note, when cutting we try and make the meet points as perfect as we can. A meet point is where the tips of the triangles meet. In this case the tip of the triangle meets the joining point of two girdle facets.

Onward to 41 degrees and the next tier.

So, even though the first second tier is now triangles, the third is going to end up being parallelograms.

Last tier using 39 degrees.

Ok... so I made a mistake here. I outlined the facets with an aluminum pencil to make it easier to see the issue. I didn't realize that this last tier was going to cut as fast as it did, and I over cut the first facet of the tier.

Good news: I can go back to the second tier at 55 degrees and recut those facets, then iterate back through the other tiers.

Bad news: I have to recut all of those facets again.

Next time I'll have the pavilion cut and polished and ready for transfer.

top 2 comments

sorted by: hot top controversial new old

[–] [email protected] 3 points 1 year ago (1 children)

Has it ever happened where a crack/flaw appeared that was deep inside the stone, to the point you just couldn't reasonably polish it out? Is the stone ruined at that point?

[–] Crylos 2 points 1 year ago

That is an interesting question, because the answer is it depends. 😉

Some stones are almost impossible to find without imperfections inside, emerald and tourmaline for example.

Generally we look closely at the stone inside and out to sort of map out and decide how to cut the stone, imperfections included. A really good faceter can align the cut to maximize yield and hide small imperfections in places that are very hard to see. For expensive stones, sapphire etc., you want to maximize the yield to maximize profit.

In the cas of the stone I’m cutting, this imperfection was likely on the side that I cut off. I didn’t see it and missed it when I roughed in the girdle and second tier. Once I moved to 1200, it became obvious. Since this is just clear topaz I just cut the stone down.