MICROCONTROLLERS

804 readers

1 users here now

Everything microcontrollers: projects, questions, new releases, etc.

dragontamer's Beginner Guides:

Beginner Series I: What is a Microcontroller?

Beginner Series II: The "Generic" Microcontroller

Beginner Sidenote: Microchip's Signal Chain Design Guide

Beginner Series III: Skills and Complexity Tiers

Beginner Series IV: Deep Dive into Microchip's AVR EA

founded 2 years ago

MODERATORS

[email protected]

Using magnet wire as hookup wires for mcu to sensors in the same enclosure? (self.microcontrollers)

submitted 1 year ago* (last edited 1 year ago) by LazaroFilm to c/[email protected]

4 comments fedilink hide all child comments

I want to wire an MCU to an IMU board and some Lemo sockets inside a 3D printed enclosure but the silicone wires I use are a pain to deal with in such a small case. Is there a counter indication to using magnet wires to hook them up? My 22 awg magnet wire is thinner than my 36 awg silicone wire.

you are viewing a single comment's thread
view the rest of the comments

[–] LazaroFilm 1 points 1 year ago

I’m not 100% sure where you’re going with this…