Faceting

362 readers

1 users here now

Community for discussing faceting and gemstones.

If you are a cutter, show off your work, provide tips and tricks or ask for advice.

If you don’t cut stones, feel free to ask questions!

No selling of stones, rough or anything else. You can however post links to vendors that you recommend.

founded 1 year ago

MODERATORS

Crylos

Quartz is really challenging - prepolish tips? (pxlmo.com)

submitted 1 year ago by [email protected] to c/faceting

8 comments fedilink hide all child comments

I feel like the garnet I cut first lulled me into a false sense of security. I did myself no favors picking a more complex cut, either. Quartz is ANNOYING!

The video mercifully does not show it, but my meetpoints are absolute trash on this stone. I used way too much force and popped it off the dop when polishing my pavilion, so my girdle and my crown don't quite align either.

I struggled heavily with the prepolish step, which in turn led to my polish taking ages. I'm currently using a Zinc+ with 8k Pandimonium which was dreamy on my garnet but the quartz was less enthusiastic about it. Am I just underestimating quartz? What do you guys use for prepolishing?

you are viewing a single comment's thread
view the rest of the comments

[–] Procleus 4 points 1 year ago (1 children)

From my own experience, it’s the prepolish to polish step that give so much trouble with quartz. I usually get around this by doing a very clean 3k grit pre-polishand then go straight to polishing. Ideally I’d like to use a good 8k prepolish but with quartz being so finicky in regards to contamination and scratching, I get better results without it.

If I want to do quartz right, and get clean flat razor-sharp facets, this is what I do. I have an old solid steel crystalite lap that is 3k Diamond and pretty worn. Does an excellent prepolish. Then I go straight to 50k Diamond powder on a gear loose BA5T lap. For the best way to charge the lap, I’d watch videos on how Roger Dery does it. It’s basically the same technique I use and it works every time, albeit it’s expensive.

If you want a way that’s quick, cheap, and VERY easy, go directly from 3000 grit (steel topper lap works fine here) pre-polish to a cerium oxide Mylar pad (spectra or similar). Mylar pads are known for facet rounding but you can minimized this a great deal with very light pressure.

Good luck!

[–] [email protected] 3 points 1 year ago

Oh man, I could use some good videos on how to charge laps, I am so concerned I'm probably overdoing it when I do mine. I will check him out!

Universal consensus is that I need a 3k lap, so I guess I'll be buying one soon! Thanks for the advice! 🙏