this post was submitted on 16 Jun 2023
8 points (90.0% liked)
Woodworking
419 readers
1 users here now
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Could you use a jig to hold the piece vertically and clamp to keep from rotating, with the to be rounded part pointing down and a router table with roundover bit?
I was thinking horizontally. I'd hesitate to do it vertically since gravity would be pulling the stock into the bit. If anything went wrong it's not exactly fail-safe.
I think the roundover bit is your best bet. But you don't have to go vertical. Horizontal, perpendicular to the fence of a router table. You will need to build a jig somehow.