Just for fun!
Made a shape out of gray self-drying hobby clay, took a (very clumsy) silicon mold of it, and now I have a fun shape to pour excess soap into if I make too much for the main mold.
On the left: clay thing. On the right: lavender soap.
this post was submitted on 08 Jan 2025
90 points (98.9% liked)
Soap Making
186 readers
2 users here now
Do you make soap? Talk about it!
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I have a question — is there any way to smoothe out the grooves made by the 3d printing prpcess? Is there any good site I can look at that catalogs these techniques?
You could spray paint the printed model with sandable primer. Then you can sand and spray it repeatedly until you get the finish you are looking for.