this post was submitted on 14 Jul 2023
8 points (100.0% liked)

3D Printing

4581 readers
1 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 4 years ago
MODERATORS
[email protected]
8
Bacon-y edges (lemmy.ml)
submitted 2 years ago* (last edited 2 years ago) by [email protected] to c/[email protected]
4 comments fedilink hide all child comments
 

Ordinarily, I wouldn't turn down bacon for any reason, but in PLA it looks kinda bad. Any ideas as to cause and, more importantly, prevention?

Image

you are viewing a single comment's thread
view the rest of the comments
[–] plateado 1 points 2 years ago

So as the other comments said, I also think your Noozle is too close to the bed. Do a calibration print on the middle of the bed. If you adjusted your z-offset then to a calibration print which includes the corners of your bed or just use a abl.