this post was submitted on 04 Sep 2024
169 points (75.7% liked)

Cool Guides

4692 readers
2 users here now

Rules for Posting Guides on Our Community

1. Defining a Guide Guides are comprehensive reference materials, how-tos, or comparison tables. A guide must be well-organized both in content and layout. Information should be easily accessible without unnecessary navigation. Guides can include flowcharts, step-by-step instructions, or visual references that compare different elements side by side.

2. Infographic Guidelines Infographics are permitted if they are educational and informative. They should aim to convey complex information visually and clearly. However, infographics that primarily serve as visual essays without structured guidance will be subject to removal.

3. Grey Area Moderators may use discretion when deciding to remove posts. If in doubt, message us or use downvotes for content you find inappropriate.

4. Source Attribution If you know the original source of a guide, share it in the comments to credit the creators.

5. Diverse Content To keep our community engaging, avoid saturating the feed with similar topics. Excessive posts on a single topic may be moderated to maintain diversity.

6. Verify in Comments Always check the comments for additional insights or corrections. Moderators rely on community expertise for accuracy.

Community Guidelines

By following these rules, we can maintain a diverse and informative community. If you have any questions or concerns, feel free to reach out to the moderators. Thank you for contributing responsibly!

founded 1 year ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] MrEff 8 points 2 months ago

The grenade thing depends on the generation of grenade. Also depends on the country of origin. Assuming we are talking about the American M67 one you see in most movies, there are 3 different generations of safeties.

Quick basics of an American grenade- the spoon is the handle looking thing that is sticking out the top and runs along the side. Under it in the head of the grenade is a spring that is always trying to push the spoon off its hinge and make it fly off, while then starting the fuse and the whole bang process. The safety pin (a codder pin with a ring on one side to pull on) runs through the head of the spoon and is held in place simply through binding into its hole/channel by tension provided by the spring. For a little bit of extra safety the end of the pin sticks out about a quarter inch and is bent for a little, but easily straightened and pulled out with the ring (look up a picture and you will see what mean).

The old ones were just the safety pin held in place by the spring/spoon mechanism. But if you had excessive vibration or just enough pressure and you had pre-straightened the safety for pulling ease, it would negate the spring pressure and the safety pin could slip in and out with ease (thus easy to pull with teeth for Rambo effect). People didn't trust it, so it was typical to then use electrical tape to hold the spoon down wrapped around the full body and then a bit extra folded back to make a quick pull tab. To throw: pull e-tape, pull pin, throw. The army then added a secondary safety to the safety. It was this secondary safety clip that held the spoon down to the head, providing constant tension and stopping the vibration loosening issues. They were also intentionally designed to have to get pulled off in opposite directions. To throw: (I am left handed) sweep safety clip left, pull pin right, throw. This was in my opinion the best setup and my favorite of grenade generations. Apparently this was about 50/50 with other others. So the army then came out with their third generation, the "confidence" thumb guard thing. It is a metal flap switch that locks/latches the safety clip onto the pin ring. I thought it was dumb. Most people hate it. But credit where credit due- it is impossible to fuck it up. Now to throw: thumb/sweep up on confidence latch, sweep left on safety clip, pull right on pin, throw.