Woodworking

6614 readers

4 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @[email protected] whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

[email protected]

Does anyone have a trick for this problem with self-driving screws? (lemmy.ca)

submitted 6 months ago* (last edited 6 months ago) by [email protected] to c/[email protected]

8 comments fedilink hide all child comments

Situation: using a screw gun to drive in the self-driving screws (the star shaped ones) horizontally, and sometimes at a difficult angle above my head. Hard to get good leverage like that. The driver starts spinning the screw but it doesn’t catch right away and then the screw jumps out and falls on the ground.

Has this happened to you? Is there a trick for that?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 6 points 6 months ago

I see a lot of good responses but id also like to add: Drill a hole first if you can. Use a bit smaller then what your screw is, and only drill enough to be able to slide the screw into the hole.

You could also do this with a hammer and punch tool, provided you can reach.

This also doubles as a benefit for wood, you're unlikely to split or crack the wood if you pre-drill the hole.