☕ - The hot beverage that powers the world!
Coffee gadgets - It's always great to learn about new gadgets. Please share your favorite hardware or full setups. It might inspire newcomers to experiment!
Local businesses - Please promote your local businesses. If you are not the owner of the business you are promoting, kindly ask the owner if it's okay. It would be great if the business has a physical store to include an exterior or interior shot.
Haven't really used a mocha pot before, so I'm experimenting a little to find the right grind settings and ratios for my taste. Normally brew espresso on a flair classic. Went with this more modern design from bialetti because it also works on induction stoves.
I’m using my moka pot on an induction stove that goes from 1 to 9, and there’s also a P setting for max power. Normally, I just use P or 9 to make the water boiling hot. Then I leave it at zero and assmble the whole pot. After that, I set it to 2, and wait. Letting the water cool down just a little at zero heat is important. If you keep the stove at 2 while assembling the moka pot, you’ll get the water flowing way too fast, and you’ll get under extracted weak coffee.
There’s a reason for doing it this way. If you heat the water with number 2 power, it’s going to take way too long. If you give it more heat, it will obviously heat up faster, but it will also increase the flow way too much. On top of that, you’ll also get steam running through the grinds, and that tends to bring out all the bitter notes very quickly. Therefore, doing the extraction at the lowest heat possible is the way to go. Since the moka pot doesn’t have a pressure gauge, it’s very difficult to tell when would be the ideal time to reduce the power. In order to avoid that problem, I recommend boiling the water before assembly.