this post was submitted on 07 Jul 2024
26 points (93.3% liked)

DIY

537 readers
1 users here now

Share your self-made stuff and half-baked projects here.

Also check out [email protected]

There is also a related XMPP chat.

founded 2 years ago
MODERATORS
 

I bought this cheap bathroom vanity off of amazon and we assembled it. We cannot get the drawers on. These silver things get in the way. When I get them mounted in a way I feel is correct they prevent the drawer from closing all the way. I haven't dealt with anything like this.

Does anyone know how to mount it? I'm sure once its done Ill feel like an idiot for how simple it is.

Thanks

you are viewing a single comment's thread
view the rest of the comments
[–] darkmarx 16 points 5 months ago* (last edited 5 months ago) (2 children)

The silver things are runners with ball bearings that drawer slides on. The slides that attach to the drawer will snap into these silver runners.

Usually, you just need to align the slides on the drawer with the runners and push. They should snap in. The runners tend to slide around while connecting them. If they slide to the back, it's ok, they will still connect once you get them lined up and push the drawer into them. If you can reach from underneath, you can hold the runner in place while attaching the drawer. Do one side at a time.

If you're struggling to get it to connect, I recommend removing the slide from the side of the drawer and seeing if you can get a single slide to attach to the runner. It will click when it attaches. By doing just one, you might have an easier time seeing how it connects.

Once you figure it out, you'll need to disconnect it. There should be a little plastic lever that you hold down (or up, depending on the side) while you pull out the slide. Put it back on the drawer and see if you can connect it once it's back on the drawer.

They are a little complicated, but once you see how it goes together, it should make sense. If what I said is still confusing or if you are still struggling, reply and I'll see if I can get some pictures to explain it better.

  • Edit: A common mistake I've seen is putting the slides on the drawer backwards. The part attached to the drawer should have the flat part against the drawer. The drawer should look like this ]|_______|[
[–] SatansMaggotyCumFart 5 points 5 months ago (1 children)

That’s a much better explanation then I was attempting.

[–] darkmarx 4 points 5 months ago

Thanks Sata . . . What the fuck is wrong with you? Who hurt you? You will live rent free in my head for a long time. Just so you know, I hate you for that. You magnificent bastard, you. Bravo. Bra fucking vo. 👏👏