this post was submitted on 10 Jul 2023
46 points (100.0% liked)
DIY
62 readers
1 users here now
placeholder
founded 2 years ago
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Here's a photo of all the gears after I cleaned them (don't leave them wet like I did in this photo - they will eventually rust. I later sprayed them all with AMSOIL MP which is like WD-40).
You can see the worm follower gear is worn out BAD. The symptoms of this machine were that it would studder/skip when encountering load.