Cast Iron

Focasia dough with part pesto/mozzarella and part tomato/mad hatter/mozzarella. I decided against the traditional dimples. Did the secondary rise inside a 12" cast iron pan with lid.

Served with a choice of olive oil in combination with salt & pepper as well as extra tomato topping. Best cut with a very sharp bread knife.

I used my 13.25" cast iron skillet to bake a large carrot cake. I found the recipe online and adjusted the cooking length to accommodate the larger pan.

Homemade pizza dough and sauce in my Lodge double Dutch oven lid and Darto carbon steel pan. The dough was cold fermented in the fridge then proofed in buttered pans. I cooked the dough on the stove top briefly to help it firm up before adding sauce and toppings.

For a crispier bottom, an alternative is to preheat the pans then add oil and (carefully) spread the proofed dough into the pan before adding toppings and cooking.

What can I say? It's Friday again

First time making saganaki. Halloumi cheese pan-fried in ghee, finished with a squeeze of lemon while in the pan.

I picked this up at a yard sale and reseasoned it. There are no markings on it. Any idea what brand this is?

It actually did end up with a breath of sourdough to it and a nice chewiness. This was some starter that I had built up and maintained, dried and stored over a year ago, then rehydrated a week ago.

Experimenting with making a pesto loaf, and it came out pretty good using the Lodge loaf pan. The dough is actually made from a pizza dough recipe that I like to make pan pizza with and had extra of. For one loaf (or pizza):

• 200g bread flour
• 25g whole wheat flour
• 158g warm water
• 4g salt
• 2g instant yeast
• 9g olive oil

Mix until all the dry bits are absorbed into a sticky dough ball, and let rest for a few minutes. Then stretch it out and fold it in half once from each side (top to bottom, right to left, bottom to top, left to right) and tuck it into a ball. It should be stronger, smoother, and feel less sticky afterwards. If it still feels like a weak shaggy mess, let it rest for another 10-20 minutes then repeat the folds. Then put the dough ball in a covered container that’s twice as big as the ball and put it in the fridge overnight (it’s good for probably up to 5 days to a week, and it will actually develop more flavor that way).

Pull the dough out about 1.5 hours before you want to bake. Roll the dough out with a rolling pin to a rectangle that’s as wide as the loaf pan is long, and make the dough as long as you can roll it out without too much trouble. Spread the pesto over the flattened dough, leaving a bit of a margin along the edges, with a bigger margin at the bottom. Roll the dough from the top down into a cylinder that will fit nicely in the pan and pinch all the seams along the loaf and at the ends to seal it up.

Grease the pan with softened butter, place the loaf in the pan, and cover with plastic wrap (or whatever). Let it rise until it’s at least 1.5 times larger (probably 1-1.5 hours). When it’s close to the right size, preheat the oven to 350°F. When the loaf is risen, uncover and brush the top with melted butter. Bake for 40-45 minutes until the inside is 190-200°F. Take the loaf out of the pan and cool on a wire rack for at least 45 minutes, then slice and enjoy.

This one happens to be square!

See https://en.wikipedia.org/wiki/Vlaai

For your viewing pleasure and inspiration.

Vlaai is a typical Dutch pastry which just so happens to fit really well in a 10" cast iron skillet. Super easy to make and with the cast iron it doesn't stick to the pan. Serve with a generous amount of whipped cream and coarse sugar.

Been making flour tortillas with the press. Fresh tortillas are amazing. Mine came with a bunch of wax papers to put between the press, but I discovered they did more harm then good. After several attempts I settled on a yeast based flour tortilla recipe which I spice up with mild chili powder. Press to shape and then roll it out to size. 60 second later in a piping hot pan and you have a tortilla. Those wax papers come in handy to separate them in the freezer.

My press came pre seasoned, but I think it can do with a few more layers. What are your tips for making tortillas?

Ghee has been the MVP in my kitchen. It’s a type of clarified butter, where the water is boiled off and the milk solids are toasted before being strained out. This gives ghee a slightly nutty flavor and greatly raises the smoke point, making it suitable for high heat cooking. It’s easy - if a little tedious - to make at home, and it’s great for cooking (and seasoning, IMO) with cast iron.

As far as I understand normal cooking will create additional seasoning layers, and a cast iron skillet will get better with time. But if I only rise the temperature high enough to cook food (and not high enough where I see smoke), how does polymerization actually happen?

I thought that if there was no smoke, then polymerization was not happening, but is that the case?

Easy to make and perfect for cast iron. I tend to coat the pans between pancakes with a tiny bit of canola oil using a brush.

Wife was craving comfort food so I made us some goulash in the Lecruset last night.

Two 8" skillets, heat up the bottom, flip bottom to top and it makes a great tiny oven. In my case, cheese bagels. Nice and crispy on the outside, soft in the middle.

For your enjoyment, can be served directly from the cast iron as well. These are 8" pans. Next time I might roll the crust out a bit thinner and make a lattice on top.

https://www.thedailymeal.com/1353224/best-oil-seasoning-cast-iron-skillet/

Repeatedly oiling and heating a cast-iron skillet gives it a nonstick surface due to a chemical process called polymerization. In the context of seasoning a cast-iron skillet, polymerization occurs when the oil is exposed to high temperatures, subsequently breaks down, and forms a bond with the metal. This process is more successful if the oil you use is high in unsaturated fat. There are many vegetable oils that are rich in both mono and polyunsaturated fats, but avocado oil outperforms others due to its higher smoke point.

The smoke point of refined or regular avocado oil falls between 500 and 520 degrees Fahrenheit. By contrast, grapeseed oil, a more commonly recommended seasoning oil, is 420 degrees Fahrenheit. That's high, but it's still significantly lower than the smoke point of unrefined or extra virgin avocado oil, which is 482 degrees. 

A higher smoke point causes polymerization to occur at a much slower rate, which is precisely what yields a more solid nonstick coating. As a result, your cast iron will stay seasoned for far longer.

I have always used peanut or vegetable oil on my cast iron.

After renewal a french "cocotte", I want to know if someone here know this brand's logo. Didn't find anything on internet. I bought it in france at a garage sale. Sorry for my english. PS : it's awesome to see this community here, on lemmy.

Hello, I am looking to get myself a cast iron skillet, and I have a couple of questions I'm not finding immediate answers for:

• Does it matter what brand of skillet I get? Is there one brand better than another, especially for beginners?
• What size should I get? My main interest in CI is to make my own pizzas, but I'll probably expand out from there.
• Should I get a set with multiple sizes?

Thanks! Also, am I missing asking anything else? I don't know what I don't know. :)

Didn't know what it was walking out of the store. Just bought it because I was curious about what was written on the back and it was $6. Turns out it is a Wagner made skillet for a company that existed around 1907-1920s.

[Image description: a cast iron skillet filled with fries topped with pork sausage, fried shallots, Anaheim peppers, tomatoes, cheese and green onions.]

Not sure how to add more images but I guess the one is enough. I love baking bread in my DO. So far that and boiling corn are the only things I use it for because it’s so big for just two people (6qt).

Seared off a piece of ahi tuna for dinner last night. Get the skillet really hot, then about 90 seconds per side, and you're golden. Here's the finished plate