With a multimeter there are tons of things to check!
You can put it into OHM mode and test diode direction, the traces, and finally the switch itself!
this post was submitted on 27 Jun 2023
8 points (90.0% liked)
ErgoMechKeyboards
5876 readers
4 users here now
Ergonomic, split and other weird keyboards
Rules
Keep it ergo
Posts must be of/about keyboards that have a clear delineation between the left and right halves of the keyboard, column stagger, or both. This includes one-handed (one half doesn't exist, what clearer delineation is that!?)
i.e. no regular non-split¹ row-stagger and no non-split¹ ortholinear²
¹ split meaning a separation of the halves, whether fixed in place or entirely separate, both are fine.
² ortholinear meaning keys layed out in a grid
No Spam
No excessive posting/"shilling" for commercial purposes. Vendors are permitted to promote their products/services but keep it to a minimum and use the [vendor] flair. Posts that appear to be marketing without being transparent about it will be removed.
No Buy/Sell/Trade
This subreddit is not a marketplace, please post on r/mechmarket or other relevant marketplace.
Some useful links
- EMK wiki
- Split keyboard compare tool
- Compare keycap profiles Looking for another set of keycaps - check this site to compare the different keycap profiles https://www.keycaps.info/
- Keymap database A database with all kinds of keymap layouts - some of them fits ergo keyboards - get inspired https://keymapdb.com/
founded 1 year ago
MODERATORS
Thanks, I’ll have a go at the multimeter
Try to narrow down where the problem is.
First use tweezers to connect the two switch pads together and see if it outputs the key.
This way you can test that the PCB works.
If that works, try the same with the contacts inside the hotswap socket.
If that works, try switching the hotswap socket.
I don’t think the sweep has diodes. But if it does, check if the direction is correct.
Thanks. I didn’t install hot-swap sockets, but I’ll try you other suggestions.
Normally Ive had bad switches you could pop it open and make sure something isnt wrong or if it's easy enough swap it with a spare
I hadn’t really thought about the possibility of the switch being the problem, I might check that out if nothing else fixes it. Thank you
Did you install hot swap sockets?
I recently built a board and smushed the pins on one switch while I was hurriedly installing them. All was fine once I pulled it out and straightened the pins.
I didn’t install hot swap sockets no, that’s why I expect that I maybe have made a cold connection or something when soldering the switch. Thanks for the advise though