this post was submitted on 24 Jul 2023
13 points (100.0% liked)

Soldering

467 readers
1 users here now

This community is for electronic hobbyists to discuss projects and is focused on soldering. Everyone is welcome from the noob to people who have been soldering as a hobby for decades to people who solder professionally. We'll talk about materials and techniques, equipment, and projects. Everyone is welcome. All questions are welcome. Post photos and ask for help.

RULES:

  1. All Lemmy.ca rules apply here.

  2. Everyone (see rule 98) is welcome.

  3. If you’ve seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.

[Did you actually think there were 98 rules?]

  1. If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.

  2. Don’t be a dick. Yes, this is a catch-all rule.

  3. The mod(s) have the final say.

founded 1 year ago
MODERATORS
[email protected]
13
Practice repairing broken traces (lemmy.ml)
submitted 1 year ago* (last edited 1 year ago) by [email protected] to c/[email protected]
1 comments fedilink hide all child comments
 

I got myself a T12 clone station recently. I've only had a junk iron that plugs into a wall socket and heats up to full blast whatever temperature with the big giant tip. Not very useful for more precise work.

I had this damaged Arduino Pro Micro clone sitting in my box of random stuff. At some point in time I had decided cut out out 4 pin headers for some reason. Damaged the corresponding traces in the process.

The repair worked! It was the MOSI, MISO, CLK, and RESET pins on the board. These pins can be used to have this board flash another Arduino board.

top 1 comments
sorted by: hot top controversial new old
[–] [email protected] 4 points 1 year ago

You did a good job of making those connections with BIG wire. I use enameled wire to make repairs like that. I have rolls on my desk that run from 0.1 mm up to 0.4 mm. You stick the wire in the solder and heat it with your iron until the enamel burns off. It's called a bodge and the wire is called bodge wire.