Ask Electronics

3173 readers

43 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago

MODERATORS

[email protected]

Help identifying a (proprietary?) PSU fan connector (self.askelectronics)

submitted 1 year ago by joenforcer to c/[email protected]

9 comments fedilink hide all child comments

I'm trying to replace the jet engine fan inside the PSU of a Nu 1.1 with a Noctua equivalent and am having trouble identifying the connector. The PSU is a Delta Electronics Model EDPS-250AB A, Part Number 400-5494-91.

I have taken several pictures of the fan connector and its header in the hopes of identifying the connection. I originally thought it was a JST-EH 2.0, but it is not, and the only means of comparison that I currently have.

Photos here: https://imgur.com/a/JQVahV3

Please help!

you are viewing a single comment's thread
view the rest of the comments

[–] glarf 3 points 1 year ago (3 children)

See if you can swap the connector, those pins can be released if you gently lift the locking tabs and pull the wire away from the connector. The metal connectors from your replacement fan might not fit into the original, but it's worth a try.

[–] joenforcer 1 points 1 year ago (2 children)

Thanks for this suggestion! Is there any chance of breaking the connector by doing this? I replied to another commenter, but to emphasize, I am only looking to modify the fan and connector as a last resort because of how rare this equipment is.

[–] [email protected] 2 points 1 year ago

Breaking the plastic would be tough so long as you're not hammering it. The connectors crimped to the wires it's another issue and if you pull too hard you could get the wire to come off the connector if it isn't soldered.

[–] glarf 1 points 1 year ago

Yes you could break the connector if you're not careful. However at the end of the day, it's not like you can't replace both sides of the connector with standard hardware, and at the very worst you could solder the fan to the pins and cover each wire with heat shrink.