this post was submitted on 17 Nov 2023
60 points (98.4% liked)
Woodworking
6215 readers
2 users here now
A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @[email protected] whose father was inspired to start woodworking by Norm and the New Yankee Workshop.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
The amount of work on this is crazy.
What I did is make a flexible membrane out of multiple strips of tuck tape to seal between the shroud on the DeWalt's pivoting saw assembly and the bottom of the table.
Is it perfect? No, there are holes at the corners, maybe two square inches total, because Tuck tape doesn't flex asymmetrically very well. But honestly, the remaining unsealed surface area is probably still smaller than the sum of all the joints and moving parts that is created by attempting to encase the entire assembly in a large box and pass the controls through.
Maybe the geometry of the shroud on a saw stop isn't favourable? I have to say, the motor hanging off the back is certainly a major downside.
Agreed, it was a ton of work. The back of the saw was definitely the biggest struggle because of how the motor moved when adjusting tilt and height.
Sealing the blade shroud might have worked. I'd probably try that first if I did this again.