homeassistant

12180 readers

57 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago

MODERATORS

[email protected]

RGB+C+W light showing up as only C+W bulb (self.homeassistant)

submitted 2 weeks ago by ApplyingAutomation to c/homeassistant

9 comments fedilink hide all child comments

I have 4 RGB+C+W zigbee bulbs like this one: Zigbee RGB+c+w bulb

However after adding it to home assistant, they only show up as c+w bulbs:

App screenshot

What am I doing wrong? How can I get it to detect it as RGB+C+W?

you are viewing a single comment's thread
view the rest of the comments

[–] aksdb 3 points 2 weeks ago (3 children)

What ZigBee Coordinator do you use? I know deconz and zigbee2mqtt have the ability to add support for new devices via config files. But that's a bit of a rabbit hole into the ZigBee protocol. They also have forums/issue trackers where one can request support for new devices.

[–] ApplyingAutomation 1 points 2 weeks ago* (last edited 2 weeks ago) (2 children)

I'm using the ZHA connector, these are Tuya bulbs, I've had good success with other Tuya products but alas. ~ Where would I requested support?

[–] aksdb 3 points 2 weeks ago (1 children)

There is some documentation in the forum about how to add new device support or where to request it. Read it and then decide what to do.

[–] ApplyingAutomation 3 points 2 weeks ago

I found someone who, just yesterday, submitted a device support request for my exact model! The request is here, I'll watch it for a bit.